Pair of Bookcases in Black Walnut
November 11, 2014
Searching on Craig's List, I found a great deal on some live-edge rough
walnut from Missouri that was readily available in Spokane. There was
a lot of bark and sapwood, as well as end checking, but the price was right.
There was also considerable color variation in the heartwood, going from
light to dark browns, to almost purple, depending on how each piece was
resawn. I enjoy working with walnut, being a softer hardwood like
cherry, but it is usually so pricey that you need to covet each and every
little piece. However, with the economy of this purchase, I was able
to be a little more at ease with searching through the stack for the board
In order to get to know the wood, I first built this simple sofa table,
a rather basic design, but with some breadboard ends to lively things up a
bit. This was when I discovered the great variation color between the
outside edges of the 8/4 slabs and the interior when they were resawn.
In need of a two of bookcases for our lower living area, I got busy on SketchUp and
came up with a couple of plans. One was loosely based on the
Oak Drawer Bookcases
from a previous project. I like the idea of incorporating drawers in
the case, where possible, to give the piece a look of other than just
shelves, plus the added utility of having some drawer storage. The
other plan would omit the drawers but flare the legs in a Shinto style.
Instead of the mission-style cabinet ends of the Oak Drawer Bookcase, I
opted for the more traditional style of raised-panel ends for both of these pieces.
Upper and lower aprons are mortised into the legs and the panels and made to
float into a 1/4" dado cut into the legs and aprons.
Additional mortises are cut into the legs for the back upper and lower
rails, in addition to a dado into lower aprons for the bottom shelf.
Another shelf will be let into the rear legs to allow for the drawers to
slide on in the drawer case.
These shelves are mostly free-floating to allow for seasonal wood movement.
They rest in dados cut into the rear aprons and side aprons.
After the end panels are glued up, the front stretcher is cut and
dovetailed into the front leg and upper apron ends.
Drawer divider ends are mortised into the drawer shelf on the bottom and
into the front stretcher on the top. The horizontal drawer divider is
biscuted into the divider ends and mortised into the upper back apron. This
case is now ready for glue up and we are ready to move on the drawers.
As I generally cut all of my tailboards for dovetails on the band saw,
my Laguna saw had one glaring deficiency for this task -- too narrow of a
table. Having a extra leaf from my Table Saw after adding a sliding
table extension, I recently attached the leaf to the side of the band saw to
give me a comfortably-large surface for my tail board jig.
Drawers are maple sides with alder bottoms and walnut faces. While the
maple is a little harder to plane than some other woods I might have used for
drawer sides, I like the crisp look of the maple-walnut dovetails
Pieces for the top presented some challenges, as the figured pieces
selected also has considerable rotted sections that needed to be removed.
By cutting them out and gluing the boards back together I was able to obtain
the desired color and figure. The piece was finished with several
coats of wipe on oil, sanding between coats with up to 400 grit paper.